3-Inch PVC Gravity Chicken Feeder Set with Cap & Funnel

Turn a standard nominal 3-inch PVC pipe into a practical gravity-fed poultry feeder. This complete printed set includes the feeder head, a removable cap, and a filling funnel with a fun carabiner for convenient storage.

The gravity-fed design keeps feed moving into an easy-access feeding area while reducing frequent refilling. Raised sides help contain the feed and limit unnecessary waste, while reinforced sections provide additional support around the feeder body.

The included funnel makes it easier to pour feed into the top of the PVC pipe without spilling it around the coop. Its carabiner allows the funnel to be hung nearby so it is ready for the next refill.

Each set is 3D printed in durable PETG and features Wandering Shepherd Farmstead branding.

Features

• Designed for standard nominal 3-inch PVC pipe

• Gravity-fed design keeps feed readily available

• Wide, sheltered feeding opening

• Raised sides help reduce spilled and scratched-out feed

• Reinforced feeder construction

• Removable cap helps cover the top of the PVC pipe

• Filling funnel makes refilling easier and cleaner

• Fun carabiner keeps the funnel nearby between refills

• Durable PETG construction

• Wandering Shepherd Farmstead branding

• Small-batch printed at Wandering Shepherd Farmstead

Approximate Feeder Dimensions

Main feeder:
8.0 inches long × 7.4 inches wide × 8.0 inches tall

This set is designed for PVC sold as nominal 3-inch pipe, which typically has an outside diameter of approximately 3.5 inches. PVC dimensions and manufacturing tolerances can vary, so customers should verify their pipe before ordering.

What Is Included

• One 3D-printed gravity feeder head

• One removable cap

• One filling funnel

• One fun carabiner attached to the funnel

Carabiner colors and styles may vary according to availability. The included carabiner is intended only for hanging and storing the lightweight funnel. It is not designed for climbing, lifting, animal restraint, or safety use.

Not Included

• 3-inch PVC pipe

• Poultry feed

• Mounting hardware

• Installation tools

Installation

Supply your own 3-inch PVC pipe in the length needed for your coop or run. Fit the feeder head onto the lower end of the pipe and secure the pipe appropriately for your setup.

Use the included funnel to add feed through the top of the pipe, then replace the cap. Hang the funnel nearby using the included carabiner so it stays clean and easy to locate.

PVC fit may vary slightly by manufacturer. Minor sanding or another small fit adjustment may occasionally be necessary. The customer is responsible for securely mounting the feeder and PVC pipe.

Material and Care

The printed components are made from PETG, a durable plastic well suited for practical farm accessories and outdoor use.

Hand-wash with mild soap and lukewarm water. Do not place printed parts in a dishwasher or expose them to open flame or extreme heat. Inspect the feeder regularly and discontinue use if any component becomes cracked, loose, or excessively worn.

Minor layer lines, seams, and small surface variations are normal characteristics of the 3D-printing process and are not considered defects.

PVC pipe is not included.